![]() 24-volt default setting.\r\rIf not using seat switch \(Pin 5\), replace switch with jumper wire to B-.\r\rPin 4 should not be connected until after controller is turned on.\r\rController should be mounted to a paint free metal surface with thermal transfer grease.\r\rAccelerator potentiometer should travel from 0 to 5k for Min to Max speed.\r\rFuses are recommended in case of wiring short circuit.) Pin 4 should not be connected until after controller is turned on.Ĭontroller should be mounted to a paint free metal surface with thermal transfer grease.Īccelerator potentiometer should travel from 0 to 5k for Min to Max speed.įuses are recommended in case of wiring short circuit.) If not using seat switch \(Pin 5\), replace switch with jumper wire to B.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |